NanoJ V1 Example Programs

NanoJ V1

With this program, the motor can be stopped in speed, analog or joystick mode using a limit switch.
4 KB
After the motor controller is switched on, this program automatically starts the selected run profile after a chosen time.
2 KB
This program allows the user to carry out reference runs to the mechanical end stops with reduced phase current.
5 KB
With this program it is possible to start profiles 1-5 directly with the inputs 1-5.
Input 1 starts profile 1, input 2 starts profile 2 and so on.
3 KB
Back

Questions? Comments?

Do you have questions or remarks about this article?

Contact support