NP5 CANopen Online Manual

Commissioning the CANopen via the Discovery Board

To establish a connection with the NP5-08, proceed as follows:

  1. Plug in the NP5-08 at X8.
  2. Plug the jumper at X13.
  3. Set potentiometer P2 to 0 (counterclockwise as far as it will go)
  4. Switch on the termination resistor (Switch SW6 ON).
  5. Connect your CANopen cable to X2 an.
  6. Connect your supply voltage to X7.
▶   next

Contents



Privacy settings
We use cookies to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners who may combine it with other information that you’ve provided to them or that they’ve collected from your use of their services. Use necessary cookies only.