Interference-suppression circuit for overcoupling of 24V control signals

Depending on the cable type, routing and length, an overcoupling onto the neighboring control line may occur with 24 V control signals. In motor controllers/drives with wide range inputs (5–24V), this can cause a second input that is not activated to be recognized as high. To prevent this without having to change the wiring (which can be a time-consuming process), the following interference-suppression circuit can be provided at each input in use. Inputs that are not required can be connected directly to the controller ground.

Back

Questions?

Do you have questions about this knowledge base article or our products?

Contact us